New to printing. My model came out with really thick supports. And it's a huge pain to remove. Any tips I've been at it for about an hour with little progress.

Easier support removal - Improve your 3D prints - UltiMaker

Printer is scraping the first couple layers without going up? Is

Viola Davis, Inside Out - The New York Times

Are these too many supports? Also, it comes out smooth but after a

Thinner areas if support is printed, solution? : r/AnycubicVyper

I printed my supports at 15% and it's really difficult to remove. Any

Supports shouldn't be this hard to remove right? Am I doing this

Funeral Poems – Mark Your Occasion

Help Please. My print keeps missing chunks. : r/resinprinting

– Tips Tricks and Great Resources for Hand Embroidery