Hey guys so since I did the last update to be at the latest firmware my first layer is lost it’s textured finish. I tried reverting to the previous firmware and still same issue. Support asked to to check the belt tension, recalibrate and manual level. Now I’m found calibration on the K value but the one value that looks best has problems with adhesion and one corner will lift lol, if I change it back to default it will print with no lift lol. Any other ideas from the group as to what I should t
Bambu Lab P1S Review: Hot Box
Problem with First layer with all filaments . Bambulab filament included . : r/BambuLab
P1p first layer is no longer as good as before - Troubleshooting - Bambu Lab Community Forum
Almost everything I print on the P1P warps - what am I doing wrong? : r/BambuLab
Bambu Lab PETG Basic - Troubleshooting - Bambu Lab Community Forum
Best practice for printing logo in first layer (2 colors) - Bambu Studio - Bambu Lab Community Forum, g1 f1800
Very frustrating issues with first layer adhesion when printing towards edge of build volume with all filaments. Bed cleaned with soap and warm water. Manually leveled bed (per their guide). Slowed down
The 3 Best 3D Printers of 2024
Underextrusion issues in the first layers