Description Documents Description This is a plug for the PSS Shaft Seal hose barb. If your boat will not exceed 10 knots under power then the PSS Shaft Seal does not require positive water feed. The PSS Shaft Seal can simply be "vented" or you can use this plug in place of the hose barb that's inserted into the carbon stator. "Burping" The PSS Shaft Seal You will also be required to "burp" the PSS Shaft Seal whenever there is air trapped inside. Simply pull back on the carbon stator, separating it from the stainless steel rotor. This will cause a quick mist of water to spray out. Important If your boat will exceed 10 knots under power then it is required that a positive water supply be plumbed to the PSS Shaft Seal for the purpose of lubricating and cooling
PSS SHAFT SEAL PSS Shaft Seal Maintenance Kits
PSS Type A Shaft Seal, PYI Inc
Description, Includes, Documents, Description, As with any rubber hose below waterline, the PSS bellows must be inspected on a regular basis for any
PSS Maintenance Kits - For 3/4 to 2-3/4 Shafts
Hose Barb .50 x .375 FPT PP - Cleaning Systems, Inc.
PSS Shaft Seal Install Instructions - PYI Inc.
PYI Inc Fisheries Supply
Joywayus Brass Hose Barb Fitting 1 Barb x 1 Male NPT Water Fuel Air (Pack of 2) : Industrial & Scientific
PYI Inc. PSS PRO Shaft Seal
PSS T-Kit - PYI Inc.
